Weight: 0.9kg (empty)
|MAXIMIZED TOOL STORAGE CAPACITY||
Vertical Tool Pockets: 16 interior and exterior of various sizes
Includes 2 Vertical Long Shank Side Tool Pockets
Low Profile Metal Belt Clip
Quick Clip Metal Tape Holder
Bit Extension Pockets
|RUGGED MATERIALS & CONSTRUCTION||
Leather Trim Panels
D-Rings: Powder Coated Steel
12000 Polyester Tool Pockets & Body Fabric
Detachable Rubber Handle
D-Rings: 2 small
203mm Electrical Tape Strap With Swivel Hooks
Nylon Plastic Connection Clip
Warranty: 5 Years (see Veto warranty terms and conditions)
or 4 fortnightly payments of $29.00 with More info
The TP3B is a Next Generation revised version of the TP3 with a Hard Bottom, extra tool pocket depth and riveted stainless steel tape measure clip. This service pouch stands up, bottom protected, and ready to help carry and help organize your most needed tools for any job or service call. It also has a streamlined metal clip on the back.
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!