Tech MCT Special Ops
$499.95 NZD
Black and Hi-Viz yellow version of the popular TECH-MCT BLACKOUT, featuring Veto Pro Pac’s proprietary V-SWAP™ system.
The TECH-MCT SPECIAL OPS is a black and Hi-Viz yellow version of the popular TECH-MCT BLACKOUT, featuring Veto Pro Pac’s proprietary V-SWAP™ system. See included panels below. Additional panels are sold separately and can be swapped out to enable tool, gear, or job-specific storage solutions. The TECH-MCT SPECIAL OPS edition comes with the V-SWAP Tool Panel, and the V-SWAP Meter Panel. Additional panels are available and sold separately.
Download a Spec Sheet| PRODUCT SPECIFICATIONS | Height (H): 14" (35.5cm) Width (W): 12" (30.5cm) Depth (D): 8.5" (21.5cm) Weight (empty): 7lbs/3kg Internal Volume: 800in3/13L Max Payload: 35lbs/16 kg |
|---|---|
| MAXIMISED TOOL STORAGE CAPACITY | V-SWAP™ removable tool pocket panel system (panels available & sold separately) SPECIAL OPS color scheme 48 Interior & exterior pockets of varying sizes 2 external side pockets for separate meter or tool storage Neoprene meter pockets for meters/testers Holds over 50 hand tools Waterproof Polypropylene plastic base for moisture and abrasion protection Extra wide padded shoulder strap Articulating/fold-flat handle with over-molded ergonomic grip YKK® zippers |
| OTHER FEATURES | Warranty: 5 Years (see Veto warranty terms and conditions) |
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!
Related products
Tech
Accessories
Combo Deals
