SB-LDT
$360.00 NZD
The SB-LDT is a hybrid tool bag like the SB-LD with increased height for storing taller tools and equipment. The dedicated front tool section is accessible via a flap that opens from the top down to protect your tools from the elements.
SB-LDT comes with 1x Rear Meter Panel included with purchase.
Available via Special Order
The SB-LDT is a hybrid tool bag like the SB-LD with increased height for storing taller tools and equipment. The dedicated front tool section is accessible via a flap that opens from the top down to protect your tools from the elements. The flap features a zippered 2-way access pocket that can be reached from either the outside or inside of the bag. This bag also has a rear enclosed, protected tester section for sensitive equipment. It also features a shoulder strap and our V-SWAP™ panel system and includes the Rear Meter Panel shown below. Additional panels are sold separately.
SB-LDT comes with 1x Rear Meter Panel included with purchase.
Download a Spec Sheet| PRODUCT SPECIFICATIONS | Height: 343mm Width: 305mm Depth: 243mm Weight (empty): 2.1kg |
|---|---|
| MAXIMIZED TOOL STORAGE CAPACITY | Dedicated Closed-Top Tool Storage Section for quick and easy access to tools Top-down flap access with zippered 2-way access pocket, reachable from inside or outside Closed-Top Meter/Tester Storage Section w/ V-SWAP™ panel Waterproof Polypropylene plastic base for moisture and abrasion protection 1 Tape Loop 30 Total Exterior and Interior pockets 1 Stainless Tape Clip "Hang-up" hook Tarpaulin covered rear pocket for added weather and abrasion protection Detachable over-molded elastomeric grip handle Shoulder strap V-SWAP™ removable tool pocket panel system YKK® zippers |
| OTHER FEATURES | Warranty: 5 Years (see Veto warranty terms and conditions) |
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!
Related products
Everyday Carry
Everyday Carry
Everyday Carry
Everyday Carry
