MB3
$259.95 NZD
The MB3 is a large meter bag capable of storing, transporting & protecting large meters. The main bay is designed for digital manifolds, meters up to 340mm tall and/or a few select hand tools.
In Stock
| PRODUCT SPECIFICATIONS | Width: 280mm Length: 127mm Height: 355mm Weight: 1.5kg (empty) |
|---|---|
| MAXIMIZED TOOL STORAGE CAPACITY | Large main pocket with 2 padded interior pockets ideal for protecting 1 – 4 meters 13 available pockets ideal for wireless probes and small small hand tools Tarpaulin covered rear pocket for added weather & abrasion protection |
| RUGGED MATERIALS & CONSTRUCTION | Ruggedized reinforced bottom Detachable over-sized elastomeric carrying handle Electrical tape strap YKK® zippered pockets |
| OTHER FEATURES | Warranty: 5 Years (see Veto warranty terms and conditions) |
KEEP THE ZIPPERS CLEAN AND LUBRICATED
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!
Related products
Tech
$1,029.95 NZD
Tech
$579.95 NZD
Tech
$419.95 NZD
Tool Pouches
$129.95 NZD
