BT-LT Belt Lifters
$349.95 NZD
The Belt Lifters (suspenders), worn on the shoulders, provide a padded harness for the shoulders, with front and back adjustable straps clipped to 4 leather locking straps.
Available via Special Order
The Belt Lifters (suspenders), worn on the shoulders, provide a padded harness for the shoulders, with front and back adjustable straps clipped to 4 leather locking straps. Through the leather straps, the harness easily connects to the loaded tool belt, distributing weight off one’s hips, sharing the load across the shoulders. It also comes with an adjustable chest strap and 2 metal tape measure clips that are conveniently chest-located on either side of the padded harness for quick and easy tape measure access. The BT-LT Belt Lifters may be used with our Builders Belt.
Download a Spec Sheet| PRODUCT SPECIFICATIONS | Over the shoulder padded harness with carrying grip and 1" 'hang up" D Ring. 2 stainless steel tape measure clips on suspender front adjustable chest strap. Adjustable webbed straps for proper location and adjustment. 4 leather securing loops to feed belt through to connect and support weighted belt. |
|---|
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!
Related products
Tool Pouches
Accessories
Tool Apron
Tool Pouches
